NETWORK PRINTER CONTROL INSTALING OFFLINE

NETWORK PRINTER CONTROL INSTALING OFFLINE

Sometimes the printer status might display Offline when it is actually ready. Printer is off or in sleep mode: Touch the printer touchscreen or press the Power button to wake the printer and put it inĪ ready state. Or intermittent, restart the router by disconnecting the power cord, wait 15 seconds, and then reconnect it. Try opening a website to see if the internet connection is working properly. At the printer port, the green light should be steady and the orangeĬheck the network connection: Move the printer and computer or mobile device closer to the WI-Fi router, and then check if Wired (Ethernet) network connection: Connect the network cable to the printer Ethernet port and to an available port on the router or access point. The blue bar stops flashing when the connection completes. Within two minutes, press and hold the WPS button on the router until the connection process begins.

Wi-Fi connection for HP Deskjet 60, ENVY 60, and Tango printers: Press and hold the Wi-Fi button and the Power button on the back of the printer for five seconds until the blue bar flashes. The printer wireless light stops flashing Within two minutes, press and hold the WPS (Wi-Fi Protected Setup) button on the router until the connection process begins. Wi-Fi connection for most printers without a touchscreen control panel: Press and hold the Wireless button for five seconds or until the wireless light starts to flash. Wi-Fi connection for printers with a touchscreen control panel: Open the Setup, Network, or Wireless settings menu, select Wireless Setup Wizard, and then follow the instructions to select the network name and enter the password. Connect the printer to the same network that your computer is connected to.

Network Printer Control instaling